Use : To enhance and protect interior wooden surfaces, especially panelling, sarking, wooden

furniture and fine woodwork, designed as a one coat treatment. Also suitable for low to

medium traffic floors. Easy care and repair. Not recommended for constantly wet areas.

Surface Preparation : The surface must be absorbent, even, dry, clean, free of grease and chemically neutral.

Fine sand to a minimum of 120/150 grade paper and dust off thoroughly.

Application : Priming the surface is not required. Stir well, apply with a good quality bristle brush or

mohair roller. Temperature must be at least 8 deg C. Do NOT wipe off excess. Buff out

after drying, best within the time frame of 10 minutes to 1 hour. The longer you wait

before buffing the less the patina.

In situations of wear and on very absorbent timbers a second coat may be required; in this

case the surface must be buffed between coats.

Treat floors after 5 days with undiluted ‘natur microwax’. Apply sparingly and buff

afterwards.

Maintenance : Use ‘natur microwax’ (4 capfuls into 5L water) as your cleaning agent when damp

mopping. This will continue to feed the surface and properly maintained, you will have a

surface for life. ‘natur microwax’ can be used undiluted at any time to add a patina and to

increase water resistance,

(recommended for kitchen areas).

Safety Instructions : Keep out of reach of children. Do not pour oil residue into the

sewer. Let the remnants dry out and dispose of with your

domestic rubbish collection, 'flamable products'.

Do not crumple soaked rags (otherwise spontaneous

combustion may occur).

Composition : Citrus Turpene, linseed oil, linseed stand oil, castor stand oil,

tung stand oil, dammar, beeswax, canauba wax, zink-chalk

colophony, glycerine ester, silicate clay, plant alcohol, cobalt

zirconium dryer (lead free).