|
Composition : Citrus terpene, linseed oil, linseed stand oil, rezinene oil, tung
stand oil, dammar, zinc-chalk colophony, glycerine ester, lead
free dryer.
Use : For interior/exterior solid timber, particle board, plywood and slate.
Easy to apply 2/3 coat system, no primer required, pleasant citrus fragrance during
application and curing. Contains no biocides nor preservatives and is safe for man, animal
and plant when dry. Safe for children’s toys.
Preparation : The surface must be dry, clean and free of grease. Special care should be taken to remove
any dust from the pores of the timber.
New surfaces : Sanding must be even and completed to a high standard. The final sand should be fine
using a 120 grade paper.
Renovated surfaces : Old, well preserved oil coatings should be thoroughly cleaned and
given a light sand. Apply 1 to 2 coats of floor oil. Old damaged and weathered coatings
should be completely removed and then treated as a new surface.
Application : Apply the resin oil sparingly and evenly, using a paint brush, roller or suitable applicator.
Remove any excess oil which has not penetrated after 10-20 minutes (visible as shiny
areas), using a clean, absorbent cloth. For large areas use an old towel on the end of a
broom.
Let dry for 12 hours between coats. Depending on the timber, several applications of
resin oil should be applied. A typical floor will require two coats of oil.
Heavy traffic areas are best treated with three coats.
A final coat of undiluted ‘natur microwax’ is optional and can be applied to give the floor a
slightly richer patina. The easiest way to buff the microwax is to put a clean towel on the
end of a broom and buff firmly in the direction of the grain.
Maintenance : Use ‘natur microwax’ (4 capfuls into 5L water) as your cleaning agent when damp
mopping. This will continue to feed the floor and properly maintained, you will have a
floor for life. ‘natur microwax’ can be used undiluted at any time to add a patina and to
increase water resistance, (recommended for kitchen areas).
Cleaning of implements : Clean Brushes and rollers in citrus thinners or turpentine, followed by warm soapy water.
Safety Instructions : : Keep out of reach of children. Do not pour oil residue into the
sewer. Let the remnants dry out and dispose of with your
domestic rubbish collection, 'flammable products'.
Do not crumple soaked rags (otherwise spontaneous
combustion may occur).
Composition : : Citrus terpene, linseed oil, linseed stand oil, rezinene oil, tung
stand oil, dammar, zinc-chalk colophony, glycerine ester, lead
free dryer.
|